| Degree of protection (IP) | IP20 |
|---|---|
| Shock | 15 G peak for 11 ms duration (??1.0 ms) |
| Vibration | 0.152 mm (0.006 inch) displacement, 1 G peak |
| Number of analogue outputs | 2 |
|---|---|
| Mains voltage | 540 V |
| Integrated breaking resistance | No |
| Brake IGBT | Without brake IGBT |
| Internal communication module | No communication module |
| Input voltage rating | 540V DC precharge |
| Logic control ride-thru | 0.5 seconds minimum, 2 seconds typical |
| Brake resistor | No internal brake resistor |
| Documentation | Manual |
| Carrier frequency | 2, 4, 8, and 10 kHz. Drive rating based on 4 kHz |
| Encoder quadrature | 90 degrees, ??27 degrees at 25 ??C (77 ??F) |
| Digital input latency, typical | 9.2 ms @ stop signal for SVC motor control |
| Heat sink thermistor | Monitored by microprocessor overtemp trip |
| Digital input latency | 9.2…16.0 ms @ start signal for SVC motor control |
| Drive to motor power ratio, max | Recommended not greater than 2:1 ratio |
| Stop modes | Multiple programmable stop modes including ?? Ramp, Coast, DC-brake, Fast brake, Ramp-to-hold and S-curve |
| Frequency accuracy | Digital input: within ??0.01% of set output frequency |
| Acceleration/deceleration | Two independently programmable accel and decel times. Each time can be programmed from 0…3600 seconds in 0.1 second increments |
| Analog input latency, typical | 6.4 ms @ speed signal for SVC motor control |
Đánh giá
Chưa có đánh giá nào.